Introduction; Fitting The Xci Adapter - Miele XCI-AD Mode D'emploi Et Instructions De Montage

Introduction

The XCI adapter allows payment sys-
tems from Miele and other suppliers to
be connected to the Miele Profes-
sional machine.
Servicing, modification, testing and
maintenance of electrical appliances
must be carried out in accordance with
all appropriate legal requirements, acci-
dent prevention regulations and valid
standards.
All regulations of the appropriate utility
supply companies and standards relat-
ing to electrical and general safety that
apply at the installation site must be ob-
served.

Danger of injury due to electric
shock.
Even with the machine switched off,
mains voltage may be applied to
some components.
The Miele Professional machine must
be disconnected from all live wires
before performing any work on the
machine or the XCI adapter.
A machine safety check must be car-
ried out in accordance with national
regulations (e.g. VDE 0701 in Germany).
The XCI adapter must be accessible at
all times to enable service work to be
carried out.

Fitting the XCI adapter

The XCI adapter can be screwed onto
the wall or attached to the wall or the
back of the machine using the adhes-
ive strips provided.
- The XCI adapter must be screwed
into place properly on site.
- If you are using the adhesive strips
instead, please note:
– The adhesive strips provided are
attached to the rear of the XCI ad-
apter.
– Mounting on the rear of the ma-
chine: the surface of the machine
must be free of grease and dust.
– Mounting on the wall: the surface
of the wall must be smooth and
solid with no traces of grease or
dust.
It must not be covered with tex-
tured wallpaper, textured plaster or
any other surface finish with inad-
equate adhesion properties.
– The maximum mounting height
must not exceed 1.50 m.
Do not install the XCI adapter above
exposed water, gutters or similar
systems.
en - English
37