CTC CLATRONIC BS 1238 Mode D'emploi & Garantie page 40

5....-05-BS 1238 Neu
GB
1 Cable
2 On/off switch /
Vacuum power regulator
3 Carrying handle
4 Cable-winding key
5 Dust bag compartment
6 Dust bag filling display
• Insert the connection head of the suction hose into the hose connector (9) until
it locks in place. To do so, please press the buttons simultaneously. In order to
release the hose again, please press the buttons once more on the connection
head.
• Keep the buttons pressed down and then pull out the hose.
• Please attach the telescopic suction tube to the grip end (see section
"Telescopic Suction Tube").
• Then assemble the floor nozzle and/or the accessories.
1. Unwind the length of cable (1) you require.
2. Insert the mains plug into a correctly installed 230 V, 50 Hz power socket. Turn
on the device with the on/off switch (2) by pushing the regulator downwards.
3. Adjust the suction power by turning the suction power regulator (2).
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Telescopic Suction Tube:
1. This makes it possible to adapt the height to your individual body size. Unlock
the coupling by turning the wide section of the suction tube to the left.
2. Move the suction tube as required. To lock the coupling, turn the wide suction
tube to the right.
40
14.09.2004
Overview of the Components
Start-up
Using the Appliance
For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
8:33 Uhr Seite 40
7 Handle for opening the dust bag
compartment
8 Filter cover - Outlet filter
9 Hose connection
Accessories (not shown):
"2-in-1" nozzle
(groove and brush nozzle)