Operation Start Procedure - Kamikaze Volpi KV 100 Manuel D'utilisation

ElEctrical PolE PrunEr

13. operation start procedure

Please wear suitable cloth and glove when operate this tool. Always
check tools before use, make sure on/off switch and safe switch are
all ok. The power should be put off when you loosen the trigger.
Stop using the tool in case of switch failure. Always check rated
voltage of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure
blade stop fully before touching it, otherwise blade will hurt your
body.
• Turn on the power switch. After warning tone, please pull the trigger two
times without holding. And the shear will be on working condition after one
more warning tone. Don't overload cutting, it will protect pruning shear and
battery not be damaged.
• Don't cutting over the dimension specified in the technical information table.
• User just loose trigger when the blade has been jammed by branch, the
blade will resume maximum position.
CAUTION
Don't sway the pruner from the left to right in order not to damage
the edge of blade during the resume process of blade. Check the
working frequency of the blade in order to verify the good working condition.
13.1 change the open Size of blade:
You can adjust the open size of blade from big open size to small open size.
Please identify the length of warning note when press the black button on the
shear. If warning note is long, it means the cutting size is big, if it is short, it
means the cutting size is small.
Please see as below: When the open size of blade maintain maximum
position, please press the trigger and maintain 3 seconds. Then the blade will
keep closed state. When you loose the trigger and press the trigger 2 times
continuously, the open size of blade will be changed into small opening size.
70
www.kamikazevolpi.com