Ratings - Hurricane HBFI 75-1 Mode D'emploi

Petrol brushcutter

RATINGS

Model
Engine output
Engine type
Cubic capacity
Fuel
Tank volume
Idling speed
Maximum engine speed
Max. speed of the cutting tool
Fuel consumption
Cutting diameter
Cord diameter
Overall cord length
Cord extension
Weight
Noise level
Vibration – racing
Vibration – idling
Technical changes reserved.
The devices are manufactured in accordance with the provisions of DIN EN ISO 11806 and fully comply with the
provisions of the German Product Safety Act.
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons
with other petrol equipment as well as temporary estimates of the load through the vibrations.
WARNING! The vibration value may vary according to the usage of the machine and its fitted equipment, and
be higher than the one indicated. Safety measures must be established to protect the user and must be based on
the load estimate generated by the vibrations in real usage conditions. In this regard, all the operational cycle phases
must be taken into consideration, such as switching off or idle running.
WARNING: This machine's starter unit generates an average sized electromagnetic field, but it is not however
possible to exclude the possibility of interference on any active or passive medical devices that operators may be
wearing; this could be risky for their health conditions. All those using medical devices should always consult their GP,
or the device manufacturer, before using this machine.
WARNING: Prolonged exposure to vibrations can cause injuries and neurovascular disorders (also called
"Renaud's syndrome" or "white hand"), especially to people suffering from circulation disorders. The symptoms can
regard the hands, wrists and fingers and are shown through loss of sensitivity, torpor, itching, pain and discolouring
of or structural changes to the skin. These effects can be worsened by low ambient temperatures and/or by gripping
the handgrips excessively tightly. If the symptoms occur, the length of time the machine is used must be reduced and
a doctor consulted.
When working with the device, a certain level of noise cannot be avoided. Noisy work should be scheduled for hours,
during which it is allowed by statute or other local regulations. Adhere to any applicable rest times and limit your work-
ing time to the necessary minimum time. For your personal protection and the protection of people nearby, suitable
hearing protection must be worn.
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require
noise protection (e.g. wearing of ear protectors).
Please do also consider any local regulations concerning noise protection!
GB | Operating Instruction
kW
cm³
lubricated petrol
ml
-1
min
-1
min
-1
min
kg/h
cm
mm
m
kg
dB (A)
m/s
2
m/s
2
GB-4
HBFI 75-1 Hurricane
0,8
2-stroke
25
40:1
500
3000
10500
8500
0,38
43 (Blade = 23)
2,0
2 x 3,0
Tap'n go
6,5
97,4 [K 3,0 dB(A)]
2
9,839
[K 1,5 m/s ]
[K 1,5 m/s 2 ]
3,192