Adjusting The Playback-Speed; Cueing; Memorizing A Sequence (Loop-Function); Faderstart - Omnitronic CDT-150 Mode D'emploi

6.6 Adjusting the playback-speed

Possibility 1:
Via the Pitchfader, you can adjust the playback-speed by up to +/-16 %.
Put the CD-player into playback-mode. Press the Pitch-button in order to activate the Pitchfader (LED on).
Select the speed-adjustment range by pressing the 8/12/16%-button.
Adjust the playback-speed via the Pitchfader (Pitch-LED of the respective speed is on).
Possibility 2:
Via the Pitch Bend-buttons you can adjust the playback-speed temporarily.
Put the CD-player into playback-mode. Press the desired Pitch Bend-button. After releasing the Pitch Bend-
button, the player automatically returns to the original playback-speed.

6.7 Cueing

Calling a Cue-point:
If you press the Cue-button during playback, the player returns to the track-start or Cue-point (In-button) and
goes into Pause-mode. Please note that this function is only available within one track.
Setting a Cue-point:
The player is in Playback-mode.
Press the Loop In-button and the Cue-point is memorized. The red Cue-LED shortly flashes twice.
As soon as you press the Cue-button, the player returns the Cue-point and goes into pause-mode.

6.8 Memorizing a sequence (Loop-function)

With the Loop-function, you can repeat a programmable sequence. Please note that you can only recall this
sequence within one track.
Memorizing Loop-points:
If the In-button is pressed in playback-mode, the CD keeps running and the A-point (starting-point) is
marked. By pressing the Out-button, the B-point (end-point) of the sequence is marked.
The player repeats the sequence between A-point and B-point until you press the Out-button once more.
You can repeat the sequence if you repress the Loop Out/Reloop-button.

6.9 Faderstart

With the CDT-150, you have the possibility to start the respective CD-player direcatly from the mixer. Make
sure that the Control-socket is connected with the respective socket on the mixer. Additionally, the Audio
Out-sockets have to be connected with the Line-input sockets of your mixer. Please note that the Faderstart-
function only works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode).
Start playback from your mixer.
Please note that the Faderstart-function is a Cue-point Faderstart-function. This means that the CD-player
starts playback after activating the respective channel of the mixer and goes into Pause-mode and returns to
the Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.

6.10 End of operation

Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off.
22/44 10602277_V_1_0.DOC