Velleman CAMCOLMS1N Mode D'emploi page 6

6.2 Starting the microscope
1. Install the microscope on the stand.
2. Use the included cable to connect the device to a USB port on your
computer.
3. Double click the MicroCapture icon on your desktop to start the
software.
The software will start and display the image from the microscope.
4. If necessary, use the wheel [2] on the device to adjust focus.
6.3 Capturing an image
 To capture an image, click the camera icon in the toolbar.
Captured photos are saved automatically and image thumbnails will be
available on the Photo tab on the right of the window for further editing.
6.4 Capturing video
1. To capture video, click the video camera icon in the toolbar.
The icon will start flashing.
2. To stop recording, click the icon again.
Captured video is saved automatically and displayed on the Video tab
on the right side of the window.
Note
The most appropriate pixel setting for video capturing is 640x480 (see
section Preview size below for settings).
V. 01 – 17/01/2018
CAMCOLMS1N
6 ©Velleman nv