Lorawan Network Registers - ADEUNIS ARF8276A Guide Utilisateur

LoRaWAN Smart Building MOTION - Guide utilisateur / User guide version V1.0.0
S390 4 Event counter for the button (Digi-
tal Input1)
S391 4 Event counter for the button (Digi-
tal Input 2)

3.3.2 LoRaWAN Network Registers

The list of registers below allows you to change the network parameters of the device. This list is accessible in PROVIDER mode following
execution of the ATT63 PROVIDER command
These registers must be handled with caution because they could cause problems of communication or of non-compliance with the legislation
in force.
Register
S201 Spreading Factor (SF) by default
S204 Reserved
S214 LORA APP-EUI (first part – MSB)
S215 LORA APP-EUI (second part – MSB)
S216 LORA APP-KEY (first part – MSB)
S217 LORA APP-KEY (second part – MID MSB)
S218 LORA APP-KEY (third part – MID LSB)
S219 LORA APP-KEY (fourth part – LSB)
S220 LoRaWAN Options
S221 Mode of activation
Description
Decimal Default: 0
Min/max: 0– 4294967295
Value reset to 0 with a Power-On reset
Decimal Default: 0
Min/max: 0– 4294967295
Value reset to 0 with a Power-On reset
Encoding
Decimal Default: 12
Min/max: 4 to 12
Unit: None
Hexadecimal Do not use
Hexadecimal Default: 0
Key encoded on 16 characters. Each register contains a
Hexadecimal
part of the key.
Used during the JOIN phase in OTAA mode
E.g.:
APP-EUI = 0018B244 41524632
• S214 = 0018B244
• S215 = 41524632
Hexadecimal Default: 0
Key encoded on 32-byte characters. Each of the 4 regis-
Hexadecimal
ters contains 8 characters.
Hexadecimal
Used during the JOIN phase in OTAA mode
Hexadecimal
E.g.:
APP-KEY = 0018B244 41524632 0018B200 00000912
• S216 = 0018B244
• S217= 41524632
• S218=0018B200
• S219= 00000912
Hexadecimal Default: 5
Bit 0: Activation of the ADR ON(1)/OFF(0) Bit 1: Reserved
Bit 2: DUTYCYCLE ON(1)/DUTYCYCLE OFF(0)
Bits 3 to 7: Reserved
CAUTION:
Deactivation of the Duty Cycle may result in a violation of
the conditions of use of the frequency band, depending
on the use of the device, thus violating the regulations in
force.
In the case of disabling the Duty Cycle, liability is trans-
ferred to the user.
Decimal Default: 1
Choice: (see NOTE 1 after the table)
• 0: ABP
• 1: OTAA
Details
Page 69
FR
EN
of 86