Ice Maker Performance Mode Instructions - Summit Classic Collection CLIM15 Instructions D'utilisation

Ice Maker Performance Mode Instructions (cont'd)
Please read the following installation methods before using, and choose the correct drain mode for
your situation. Set up your ice maker accordingly.
Performance Mode Instructions
Direct drainage Excess water
mode will be drained off
(Recommended by the outlet water
mode) pipe on the back of
the unit
Drain pump mode Excess water
(Recommended will be forced to drain
out by the pump on
mode)
back of the unit.
INSTALLATION INSTRUCTIONS
Suitable situation
The height of drain hole
in the room
≤100 mm (3-15/16")
The height of drain
hole in the room is
between
101 mm~1500 mm
(3-15/16"~59")
Operation instruction
Ref.: Fig. A, Fig. B & Fig. C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front) (4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
1. Please be sure the screw nut and switch are in the
above condition;
2. Use a certain length drain pipe,connect one side to
the direct water outlet pipe connection (13), the
other to the drain hole. Please be sure the
connection is tight to avoid water leakage.
Ref.: Fig. A, Fig. B & Fig. C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front)(4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
1. Please be sure the screw nut and switch are in the
above condition;
2. Use a certain length drain pipe, connect one side to
the force water outlet pipe connector (10), the other
to the drain hole. Please be sure the connection is
tight to avoid water leakage.
The lengthen of drainpipe is no more than 6000 mm
(236-4/16") in order to prevent slops return.
7
Condition
lock
open
lock
open
OFF
Condition
lock
open
open
lock
ON