Pur Line CHE600 Manuel De L'utilisateur page 9

• Never immerse the product in water or any other liquids. However should
the appliance accidentally fall into water or have water or any other liquid spilt
over it isolate and unplug the appliance immediately and have it checked by
a qualified person before using it again. Non-observance could cause a fatal
electric shock!
• Do not use the appliance with wet hands, on a damp floor or when the
appliance itself is wet.
INSTALLATION
• We strongly recommend that a professional who has experience of fitting such
items should install Wall Fireplace.
• Freestanding Fireplaces are heavy objects and your safety is dependant on the
construction/strength of the wall to which it is attached.
• At least two people are recommended to install the Wall Fireplace.
• Wall fixings must be used for stability on this item and for safety reason the
Freestanding Fireplace should be be fixed to te wall.
• Do not connect the appliance until properly fixed to the wall and the instructions
is read fully.
• The screws and plugs supplied with this package are only suitable for SOLID
wall installation. For any walls other than solid, such as cavity, the appropriate
fixings MUST be used .
• Always ensure intended wall area to be drilled is free from hidden electrical
wires, water and gas pipes.
• Remove the appliance from the box and remove any packaging from the product.
• Place the packaging inside the box and either store or dispose of safely.
• The fixing pack contains small items which should be kept away from young children.
• We suggest that you open the fixing pack and place all the contents into a container, therefore reducing the
risk of losing any small pieces.
• Inspect the air inlets and outlets to ensure that there are no blockages.
Note: All heaters may cause paint discoloration overtime or wall paper to lift.
INSTALL ON THE FLOOR
• There is a bracket at the rear of the heater at each side.
These engage behind wall mounted brackets to provide a secure
fixing method.
• Hold the heater to the wall and mark the level of the brackets. The
wall bracket is to be mounted approx. 30 mm towards the inside of
the heater.
• Hold the wall brackets at this position and mark the positions of
the screw holes.
• Drill the wall and insert the wall plugs.
• Screw the wall brackets in place.
• Hold the heater above the wall brackets and lower to fix the fixing
9