Cancel Operation; Punch Through - NAD HTR 8 Manuel D'installation

Example: Learning "DVD Pause"
Position the HTR 8 and your DVD player's
remote as described above.
•
On the HTR 8, simultaneously press-
and-hold [DVD] and [RES]; the Learn
LED turns steady green.
•
Press the HTR 8's Pause [j] key; the
Learn LED turns amber.
•
Press-and-hold the correspond-
ing Pause key of your DVD player's
remote control; the HTR 8's Learn LED
flickers amber and then turns solid
green. The command is learned.
•
Press [DVD] again to exit the learning
mode.
Notes
· The HTR 8 can learn up to 360 com-
mands making use of all the DEVICE
SELECTOR and function keys.
· The DEVICE SELECTOR keys can
themselves be configured to learn a
command.
· Press and hold a configured DEVICE
SELECTOR for at least 2 seconds to
execute a function assigned to the
particular DEVICE SELECTOR key.
· Short press of a configured DEVICE
SELECTOR will just switch the active
device.

CanCEl OpEratiOn

You can cancel configuring a key, by
pressing the active DEVICE SELECTOR key
before the learn process is complete; the
Learn LED will turn red.

PUNCH THROUGH

The HTR 8' s "punch-through" function
allows you to retain a function key from
one Device Select "page" to another, so
that, for example, the AMP [SURR MODE]
function might still control the NAD A/V
receiver when the DVD DEVICE SELECTOR
page is active.
Note
The HTR 8's [VOL D/F] keys are pre-
programmed as "punched-through"
for all Device Select pages: [VOL
D/F] will operate the NAD's master-
volume regardless of the currently
selected device. The [SURR] [CENTER]
and [SUB] Channel Volume controls
similarly are pre-programmed as
punched-through.
To set a punch through, after entering
the Learning Mode, and pressing the de-
sired key to be punched through, simply
press the device key twice of the device
to punch through to. The status LED will
turn green; press the DEVICE SELECTOR
key again to exit Learning Mode.
5