LaserLiner LAN-Check Mode D'emploi page 10

3
Wiring fault
3.1
Short (LED 6)
There is a short-circuit
between pin 2 and 3.
3.2
Miswire (LED 7)
Pins 1 to 4 are not
connected correctly.
The wiring fault miswire indicates that the pins of two twisted pairs
are connected incorrectly.
3.3
Reversal (LED 8)
Polarity of pin 1 and 2
connection reversed.
The wiring fault reversal indicates that the pins of one twisted pair
is connected incorrectly.
3.4
Break
TEST mode: The corresponding LEDs will not light if there is a cable
break in one or several twisted pairs.
Example
There is a break in twisted
pair 3 - 6.
DEBUG mode: In DEBUG mode the twisted pairs are individually
checked one after the other. Initially, the LED flashes briefly, then
lights constantly while the „OK" LED is also ON.
There is a cable break if a twisted pair does not briefly flash and is
not confirmed by the LED lighting constantly with the „OK" LED
also ON.
10
GB
ON
LED not ON
ON
ON
ON
LED not ON