Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN Application sheet
Control panel
KAMILLA (EU) Sensor
On the front panel of the kitchen hood there is a
touch switch of the motor mode and backlight (Fig.
7). Its elements have the following functions:
1.
Switching on / off the kitchen hood.
2. Reducing the speed of the motor.
3. Display speed readings.
4. Increase the speed of the motor.
5. Turning backlight on / off.
The kitchen hood is switched on/off by touching
the icon 1 for 2-3 seconds. To switch speed of the
kitchen hood touch icons "–" or "+".
With this switch, you can turn on one of the two
motor speeds, turn on the backlight or activate
"Timer" function by pressing the corresponding
button in any order. The selected speed is indi-
cated on the display 3.
To activate "Timer" function on the operating ma-
chine press and hold the "–" and "+"buttons simul-
taneously for more than two seconds. A flashing
digit of the selected speed on the display indicates
that the timer is turned on. After 1-9 minutes af-
ter the timer is turned on the kitchen hood stops
working automatically. This function is very con-
venient for removing residual smell from the kitch-
en after cooking.
INSTRUCTIONS ON THE USE OF
THE KITCHEN HOOD
The kitchen hood is to be used for extraction of
smells from the kitchen. It may work in two modes
depending on the method of its installation:
— mode of air removal into the air shaft;
— recirculation mode.
In the mode of air removal into the air shaft (see
Fig. 8, 9), the kitchen hood is connected to the air
shaft with the help of a corrugated hose or a plas-
tic air conduit. Thus, all the evaporations from the
kitchen, smells, char and soot pas through reus-
able aluminum grease trap filters and are removed
KITCHEN HOODS
outside the premises. With this working mode, it is
not necessary to install charcoal acrylic scent-trap
filters. Extraction mode is the most efficient as the
kitchen hood removes all the evaporations from
the kitchen to the air shaft.
In the recirculation mode (see Fig. 10), the kitchen
hood is not connected to the air shaft, and thus the
air is just passed through the kitchen hood inside
the kitchen.
In this mode, charcoal acrylic disposable scent-
trap filters should be installed on the kitchen hood.
These filters are not included in the set and are
bought separately. The use of the kitchen hood in
the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the
mode of air extraction to the air shaft.
MAINTENANCE AND SERVICE
Disconnect the power supply before you
start any operation related to cleaning or re-
pair of the kitchen hood.
Use the cloth damped in warm water with a neutral
detergent for external cleaning of painted kitchen
hoods. Use special detergents and follow the rele-
vant instructions for external cleaning of steel, cop-
per and brass surfaces. Never use the detergents
that contain acids or chloride, abrasive products or
sponges that may scratch the surface.
The aluminum grease trap filter becomes polluted
as it traps the particles of fat coming through it. It
should be cleaned with products that do not con-
tain acids or washed after preliminary soaking in
hot water using an efficient detergent or, if possible,
in the dish-washer (at a temperature of 65°C). Ex-
tremely polluted grease trap filters should not be
washed in the dish-washer along with kitchenware.
Aluminum filters should be cleaned once in 1.5-2
months.
OF THE KITCHEN HOOD
11
Publicité
Table des Matières
