Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN Application sheet
Simultaneously with cleaning of the grease trap fil-
ter, clean all the accessible elements of the kitchen
hood case from grease deposits.
To disconnect the aluminum filter (Fig. 11), press the
spring lock on the filter and pull it and then press
down to remove. When you remove the filter, do not
apply the effort to the aluminum surface of the filter
as it may lead to dents on its surface, affecting the
external appearance of the filter.
Do not install the filter in the kitchen hood until it
is completely dry.
The filter is installed in the reverse order. Press the
spring lock on the filter and put it in place, after
which release the lock.
Replacement of Coal filters
Coal filters are installed on the protective grates of
the exhaust motor box, located under the aluminum
grease filter. To install the filter, it must be slightly
tucked into the grate of the motor box and turn
clockwise to fix it on the grate. To remove the char-
coal filter lightly press it to the motor box grate and
rotate counterclockwise to release (Fig. 12).
Replacing the backlight lamps
To replace the backlight lamp (Fig. 13), it is neces-
sary to:
- disconnect the hood from the power supply
and find the wire of the burned lamp;
- disconnect the power cord in the connector by
pressing the two petals of the cover, remove
the burned out lamp;
- insert a new one in place of the burned-out
lamp;
- connect the lamp power wire in the connector;
- connect the hood to the power supply and
check the operation of the lamps.
Replacement of bulbs and filters is not
included in the warranty service.
12
KITCHEN HOODS
KITCHEN HOOD INSTALLATION
Only a specialist has the right to install and con-
nect the kitchen hood to the power supply.
Do not begin installation of the hood and do not
remove the protective film from the stainless
steel surfaces until you are sure of the technical
serviceability of the hood by connecting it to the
electrical network and checking all its functions.
To do this, open the package, remove the kitchen
hood and place it on a flat surface so that the switch
of operation mode are facing the inspector. Connect
the hood to the power supply and check it. If the
hood is working properly in all modes, proceed to
the installation. If not, contact the company - sup-
plier or warranty workshop. It is recommended to
remove the protective film from the stainless steel
surfaces only after the installation of the kitchen
hood.
We remind you that the hood must be installed
at least 65 cm above the electric stove and at
least 75 cm above the gas stove.
Attention! It is recommended to use two per-
sons for installation of the kitchen hood.
Before installing the kitchen hood, make sure that
the wall on which the hood will be fixed is strong
enough. For the suspension of the kitchen hood
and the decorative box lath use screws and dow-
els that correspond to the type of the wall in your
kitchen (concrete, drywall, etc.). If screws and dow-
els are included in the kit, make sure that they are
suitable for the type of wall which the hood will be
suspended on.
The installation of the kitchen hood is carried out in
the following sequence.
Your model of the kitchen hood can be installed
both to the wall and built into the hanging cabinet.
Regardless of the installation it can be used both
in the air recirculation mode and in the air exhaust
mode to the ventilation shaft.
When using the hood in recirculation mode, you
should:
1.
Install carbon filters (available separately).
INSTRUCTIONS
Publicité
Table des Matières
