Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
● When the lever is in the uppermost position, the blades will give you the
closest cut and leave the hair very short. Pushing the lever downward
gradually increases the cutting length.
● In its lowest position, the lever will leave the hair approximately the same
length as a #1 comb.
● The lever will also extend the use of
your blades since a different cutting
edge is used in each setting.
● In addition, if extremely heavy hair
cutting has jammed the blades, it will
help you remove hair that has
become wedged between the two
blades without removing the blades.
● While the clipper is running, rapidly move the lever from "close cut" to
"longer cut" a couple of times. Doing this each time after you have
finished using your clipper will help to keep the blades clear of cut hair. If
your clipper stops cutting and this does not help, your cutting blades are
dulled. Replace them with new blades.
Storage
● Keep the product in soft and ventilated place unreached by children.

IMPORTANT SAFEGUARDS

When using electrical appliances, especially when children are present, basic safety precautions
should always be followed, including the following:
To reduce the risk of death or injury by electric shock:
● Unplug this appliance before cleaning.
● Do not place or store appliance where it can fall or be pulled into a tub
or sink.
● Do not use while bathing or in a shower,
● Do not place in, or drop into, water or other liquid.
● Do not reach for an appliance that has fallen into water. Unplug
immediately.
To reduce the risk of burns, electrocution, fire, or injury to persons:
● Use this appliance only for its intended use as described in this manual.
● Do not use attachments not recommended by the manufacturer.
● This appliance should never be left unattended when plugged in.
● Close supervision is necessary when this appliance is used by, on, or
near children or invalids.
● Never operate this appliance if it has a damaged cord or plug, if it is not
working properly.
● Keep the cord away from heated surfaces.
24
Longer cut

Publicité

Table des Matières
loading

Table des Matières