Assembly - RIDGID 1000RV0 Manuel Du Propriétaire

SP6962 Pro Pack Plus ESF.qxp_SP6962 6/24/15 1:21 PM Page 6

Assembly

Installing Collapsible Pull
Handle into the Handle Bracket
1. Slide the collapsible pull handle into
the handle bracket slots.
2. Aligning the bottom holes of the
collapsible pull handle and the handle
bracket holes, place the handle bolt
through the hole and secure with the
handle nut.
3. Install the second bolt and nut and
secure both nuts just snug.
NOTE: Do not over tighten the handle
nuts, as this may deform or damage the
handle bracket or collapsible pull handle.
Collapsible Pull Handle Bolt (2)
Collapsible
Pull Handle
Handle
Bracket
Slots
Collapsible Pull
Handle Nut (2)
6
Installing Wheels and Axle
1. Locate the axle, 2 wheels and 2 cap
nuts.
2. Installing cap nut:
a. Place cap nut on the end of the
axle.
b. Gently tap cap nut with hammer
until it is fully seated onto axle.
c. Place wheel on the axle and slide
against the installed cap nut
(smooth portion of wheel facing
outward).
3. Slide open end of axle through the
handle bracket assembly as shown.
Light taps with a rubber mallet may be
required to fully insert axle.
4. Install the second wheel onto the other
end of the axle (smooth portion of
wheel facing outward).
5. Install the second cap nut. Gently tap
cap nut onto the axle until it is firmly
seated.
Cap Nut
Axle
Cap Nut (2)
Bracket
Assembly
Axle
Wheel (2)