Moving The Wet/Dry Vac; Cord Storage; Blowing Feature - RIDGID 1000RV0 Manuel Du Propriétaire

SP6962 Pro Pack Plus ESF.qxp_SP6962 6/24/15 1:21 PM Page 11
Operation

Moving the Wet/Dry Vac

Should it become necessary to pick the
Vac up to move it, the carry handle on
the top of the Wet/Dry Vac can be used
to lift.
Carry Handle
To maneuver the Vac, the collapsible pull
handle should be used. Simply squeeze
the push button, located on the top of the
collapsible pull handle, and gently pull up
until full extension of the handle is
reached. An audible click sound will be
heard when the handle is in the locked
position.
NOTE: Do not pick up or carry the
vacuum by the collapsible pull handle.
Push Button
Collapsible
Pull Handle

Cord Storage

When vacuuming is complete, unplug the
cord and wrap it up as described in the
"Cord, Hose & Accessory Storage"
Section shown on page 7.
(continued)

Blowing Feature

Your Wet/Dry Vac has the capability to be
used as a blower for yard work, patio
cleanup and workshop applications to
blow sawdust and other debris. Raise the
right cover and install the locking end of
the hose into the blower port.
Blowing
Port
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
11
Right
Cover
Locking
End of
Hose