Velleman SPBS10 Notice D'emploi page 6

*%)"*' %-) < =
Refer to the vehicle installation drawings or experienced advice when de
•
of the control unit. The control unit should not be close to potential sour
e.g. cable bundles, exhaust pipe....
Make sure the power cables of the control unit are easily accessible.
•
Use the included double sided adhesive tape to fix the control unit to the
•
- 0'$4 &%-)
The display unit should be mounted on the dashboard with the included
•
Make sure that the display is readable under all conditions.
Guide the cable towards the CU.
•
Plug the connector into the CU. The connector fits only one way, do not
•
$2'-%>?,*%%!,)-*%
Every sensor cable has a letter written on it.
•
Plug each sensor cable into the corresponding port on the CU.
•
*%%!,)-%> 0*5!"
The CU gets power from the reverse light circuit of the vehicle. Use the
•
and the included cable clips to make the connections.
Locate the +12V power cable of the reverse light circuit and guide it thr
•
Insert the red cable of the CU power cable in that cable clip and press th
•
clip tightly. Close the cable clip.
Locate the GND cable of the reverse light circuit and guide it through a c
•
Insert the black cable of the CU power cable in that cable clip and press
•
clip tightly. Close the cable clip.
Connect the power cable to the CU.
•
@( 0!"$)-*%
$"%-%> #*+!
Following is an overview of the warning zones.
•
$"%-%> A*%!
Danger zone
Caution zone
Safety zone
!5$"! *. )/! 2'-%+ A*%! 2!/-%+ )/! 1!/-,'!B
A*%! 5-''
When an obstacle is detected in a warning zone, visual and audible warn
•
display unit.
Visual warnings are given by flashing of the display indicator C Dof the s
•
the obstacle, as well as a numeric display of the distance in meter C D
when an obstacle is detected by sensor
by sensor or , the right indicator will flash.
The time interval between the beeps is an indication of the distance to t
•
shorter the interval, the closer the obstacle. See the table below for an o
When multiple obstacles are detected, the display indicators of the sens
•
the distance to the obstacle located inside the highest priority warning z
accompanying audible warnings are given.
The audible warnings can be disabled with the switch C D on the LCD.
•
31.07.2014
- )$%,!
D ≤ 0.2
0.3 < D ≤ 0.4
0.5 < D ≤ 0.9
1.0 < D ≤ 1.5
1.6 < D ≤ 2.0
2! +!)!,)!+B /! 2'-%+ A*%! 2!/-%+ )/! 1!/-,'!
<#=
2 )$,'! '*,$)!
or , the left indicator will f
6
n determining the location
sources of interference,
the cars' interior.
ded mounting bracket.
not force.
the red/black power cable
through a cable clip.
ss the metal part of the
a cable clip.
ess the metal part of the
&+-2'! 2'! ->%$'
Bi......... .............
Bi.Bi. i.Bi.Bi
Bi..Bi. ..Bi..Bi
Bi.....Bi... ...Bi.....Bi
< <
,$)!+ -% -+! )/! 2'-%+
-,'! - 7 ,#(
arnings are given on the
he sensor(s) that detected
D and a bar graph C D.
ill flash, when detected
to the obstacle. The
an overview.
ensors will flash, but only
ng zone and the
©Velleman nv