Velleman SPBS10 Notice D'emploi page 5

( !$)&"!
• detection of obstacles when the vehicle is put into reverse
• beeps accelerate as the vehicle approaches the obstruction
• long detecting distance: up to 2m, high stability
• stable LCD with built<in buzzer, showing accurate distance to and directio
• 4 black waterproof build<in sensors with a large beam angle for a minimiz
• installation height: 50<80cm
• consists of:
1 electronic control unit with 1m power cable
o
digital colour LCD with built<in buzzer & 6m cable
o
4 ultrasonic sensors with 2.5m cable each
o
user's manual, double<sided adhesive tape, 2 quick<on ca
o
• spare parts: sensor (SPBS10/SENS)
:( 1!"1-!5
Refer to the illustrations on page 6 of this manual.
Control unit
Power connector
6 Display connector
7 Sensor connector (4x)
Reverse light circuit
Sensors
Liquid Cristal Display
Sensor indication
Distance value
Sound on/off
STOP<Warning
Distance bar graph
support
;( % )$''$)-*%
Refer to the images on page 6 and 7 of this manual.
$00'4 0*5!" )* )/! 4 )!# 2!.*"! $'' ,*%%!,)-*% $"!
!% *"
Determine the location of the sensors on the bumper carefully, as the pr
•
the system depends on it.
beware that detection results might be affected when sensors are inst
bumpers.
Refer to the pictures on page 7 for the best horizontal and vertical posit
•
vehicle.
Also make sure no part of the bumper is blocking the view of the sensor
•
Mark the location of the holes on the bumper and drill the holes with the
•
(Ø21.0mm).
Remove all burrs from the edge of the holes.
•
Insert the sensors and cables in the holes. All sensors are identical but t
•
determine the indications on the LCD. Therefore it is important to moun
indicated in the illustration (A left, followed by B, C and D on the right).
Make sure the central axis of the sensor is perpendicular to the bumper
•
necessary, first slide an included washer over the sensor.
The sensors can be repainted to match the colour of the bumper. How
the paint layer may not exceed 0.1mm!
31.07.2014
microprocessor<controlled
Power is drawn from the cars' reverse li
4 ultrasonic sensors
With buzzer. When the car reverses, thi
of obstacles via audio + display of direc
the obstacle.
Indicates which sensor detects the obsta
Distance to closest obstacle.
Graphical indication of distance to closes
5
ction of obstacles
imized blind area
n cable clips and hole saw
se light circuit.
, this unit warns the driver
irection of and distance to
bstacle.
losest obstacle.
$"! #$+!(
e proper functioning of
installed in steel
osition. L=width of the
nsor.
the included hole saw
ut their location will
ount the sensors as
ht).
per surface. When
However, the thickness of
©Velleman nv