R.G.V. DUETTO PLUS Mode D'emploi Et D'entretien page 33

Make sure that the auger (H) is fitted on
the teflon coating and the metal washer
(X) and that these are intact. Otherwise,
replace them by going to a point of
sales.
a4 - Insert the auger (H) in the infeed duct (B)
attaching it to the motor pin.
a5 - Insert the extended conical auger (G) on the
auger (H).
a6 - Insert the conical sieve (C) in the infeed duct (B)
positioning it as illustrated.
a7 - Tighten the ring nut (O) using your hands.
While tightening the nut (O) with the other
hand hold the infeed duct (B).
X
H
B
H
H
G
B
C
B
O
33