Troubleshooting; Disposal - BASETech 2302702 Notice D'emploi

11. Troubleshooting

Before you undertake measures to eliminate faults, make sure that the device is switched off, the mains
plug is out of the mains socket and the device has completely cooled down.
The product does not switch on
• Check whether the mains plug is correctly connected. Disconnect the power plug from the power outlet and plug it
back in after 10 seconds.
• Make sure that the outlet is live. Connect another device to the wall outlet. If this appliance also does not switch
on, consult an electrician.
The product becomes noisy during wet vacuum cleaning
• The product features a float safety switch which closes when the maximum tank level is reached during the wet
vacuum cleaning operation. When this happens, the suctions noise of the equipment will change and become
louder.
• Switch off the product and empty the container then restart the operation.
Poor suction power
• Check whether the paper bag is full and replace if necessary.
• Check whether the tube, the hose or the nozzles are clogged.
Motor is unusually loud
• Immediately stop operation of the product.
• Check whether the tube, the hose or the nozzles are clogged.
• If the problem persists, switch the product off. Pull out the mains plug and contact a specialist.

12. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste. At the end of
its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
33