Operation; General Information - BASETech 2302702 Notice D'emploi

• Remove the motor unit from the container.
• Turn the motor unit upside down, then slide the foam filter fully onto the motor head.
• Place the motor unit back onto the container and lock in place before operating.
• Depending on the degree of dirt, the dirt catcher bag should be emptied at regular intervals whilst cleaning the pond,
and emptied and cleaned at the end of each use.

9. Operation

a) General information
• Install the necessary accessories.
• Make sure that the motor unit is installed properly and secure.
• Connect the mains plug to a standard mains socket.
• For indoor dry and wet vacuum, turn the operating mode dial to position '1' and for automatic outdoor vacuum pond
cleaning, turn the operating mode dial to position '2'.
When using operating mode 2, the motor operates for 30 seconds then switches off for 30 seconds. The
product will repeat this cycle until the operating mode dial is at position 0.
• Switch the product off after use (operating mode dial to position 0).
• Disconnect the mains plug from the mains socket.
31