Replacing The Batteries - SOLAC ECOGENIC Mode D'emploi

Side Brush (8)
,
Clean the side brush regularly to prevent malfunctioning of the robot vacuum.
1 Use your hands to remove any hair and dust trapped in the side brush.
2 If the dirt is very tangled around the brush, cut it using scissors.
,
If necessary, unscrew the screw and remove the side brush (8) from the body for more
effective cleaning (fig.17).
3 Return the side brush to its housing.
REMOVAL AND CLEANING OF WHEELS
Side Wheels
1 Unscrew the screws of the wheels (fig.18).
2 Remove the wheels from their housing and clean them.
)
Do not clean the wheels with water, oil or grease.
)
Return the wheels to their housing and screw down the screws using a screwdriver.
Front Wheel
If the front wheel is jammed or does not rotate freely, remove it for cleaning (fig.18).
1 Remove the wheel with the help of a tool that serves as a lever.
2 To replace it after cleaning, press the wheel into its housing.
CLEAN THE COLLISION SENSORS (25) AND STAIR SENSORS (27)
,
Keep the infrareds clean so that the robot vacuum can operate correctly.
1 Clean the sensors with a piece of cotton or a soft cloth (fig.19).
CLEANING THE APPLIANCE
n
Check that no water enters the appliance.
)
Clean the appliance after using it for the first time, immediately after each use and after
a long period without use. You will thus ensure the correct operation of the appliance
and prolong its useful life.
1 Clean the outside of the appliance with a damp cloth. Do not use abrasive products or solvents.

REPLACING THE BATTERIES

REPLACING THE BATTERIES OF THE VIRTUAL BARRIER (Fig. 20)
1 Turn battery cover lock (6B) until the cover is released (5B).
2 Place the batteries in the compartment intended for this purpose. Check that the
positive and negative electrodes are in the proper positions.
,
Remove the batteries if you are not going to use the robot vacuum for a long period of
time.
REPLACING THE BATTERIES OF THE REMOTE CONTROL (Fig. 21)
1 Open the battery compartment cover.
2 Place the batteries in the compartment intended for this purpose. Check that the
positive and negative electrodes are in the proper positions.
,
Remove the batteries if you are not going to use the robot vacuum for a long period of
time.
REPLACING THE BATTERIES
en
25