Using The Appliance - SOLAC ECOGENIC Mode D'emploi

• When storing the appliance for a long period of time, we recommend you fully charge
the battery and then remove it for storage in a cool, dry place.

USING THE APPLIANCE

,
This appliance has been specially designed to vacuum floors and carpeted
floors.
This appliance is intended for daily floor maintenance, avoiding the
accumulation of dirt and appearance of fluff.
)
Never vacuum live ash, splinters or other sharp objects, or liquids.
)
Never vacuum lit matches or cigarette butts. Do not vacuum toxic material (e.g.
ammonia).
)
Completely remove all the elements used for transportation and packaging.
)
Do not use the robot vacuum cleaner between small tables, chairs or very small
spaces, as this could damage the appliance.
,
The robot vacuum cleaner uses cleaning settings to effectively clean the whole floor:
Spiral movement for more intense cleaning where dirt has been detected, wall following
for cleaning the perimeter of the room and room-crossing to ensure a full clean.
,
The robot vacuum cleaner will take approximately 45 minutes to clean an average-sized
room, passing over the same area several times to ensure the whole surface is cleaned.
ROBOT VACUUM CONTROL PANEL
Start/Stop robot vacuum
Charge button:
Lights up when pressed, turns off when the robot connects to the charging
station.
Charge indicator:
Flashes during charging. It remains lit when charging is complete.
Ultra-violet lamp:
Lights up when pressed, the disinfection lamp will operate while the robot is
cleaning.
1 Remove all objects that could break or damage the robot vacuum from the floor (e.g.
lamps, bottles).
2 Check that the dustbin (11) is adequately fitted. See the section ("CLEANING AND
STORAGE").
3 Place the virtual barrier (4) where you like to prevent the robot entering a specific area.
See the section ("VIRTUAL BARRIER").
4 Start up the robot vacuum cleaner. To do so, set the operating switch (20) to the ON
position.
5 Ensure that cleaning robot is charged.
,
If the LED indicator light on the robot's control panel
vacuum to charge. See the section ("PREPARING THE APPLIANCE. CHARGING
THE ROBOT VACUUM")
6 If you want to use the robot vacuum in automatic mode, programme its operation using
the remote control. See the section ("REMOTE CONTROL").
7 Press the button on the robot's panel.
The robot vacuum will then start to operate, following its cleaning patterns.
20
flashes, set up the robot
USING THE APPLIANCE