Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR USE
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING STAPLE WELDER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR HEAT PROTECTION GLOVES
WEAR A PROTECTIVE MASK AGAINST PHYSICAL AGENTS IF THE VALUES FOUND IN THE
ENVIRONMENTAL/INDUSTRIAL ANALYSIS SURVEY EXCEED THE LIMITS UNDER CURRENT REGULATIONS
INDOSSARE SEMPRE GLI OCCHIALI PROTETTIVI
TECHNICAL DATA
NOMINAL POWER SUPPLY VOLTAGE
MAINS PROTECTION DEVICE
MINIMUM POWER
MAXIMUM POWER
HEIGHT
WIDTH
DEPTH
SOCKET CABLE LENGTH (Schuko)
GUN CABLE LENGTH
INDEX OF PROTECTION
STAPLE THICKNESS
WEIGHT
USE
Connect the power supply cable to the mains socket, checking that the mains voltage matches the voltage stated on the device
or in the TECHNICAL DATA table:
• Use the ON/OFF switch to turn the device on.
• Select the required power – MIN (e.g. for plastic 2 mm in thickness) MAX (e.g. for plastic exceeding 2 mm
in thickness).
• Take a staple of the type and shape required for the welding operation to perform; fit it into the holes of the gun
electrodes (using either the holes at the tip or those located laterally, at an angle of 90°).
• The welding operation should be performed from the nonvisible interior part of the damaged piece.
• Press the button on the gun, for a few seconds, to warm up the staple.
• Holding the parts to weld together, fit the staple into plastic, pressing slightly, and reach the required depth, keeping
the button pressed on the gun.
• Release the button, holding the staple in the required position, until it cools down (it will take a few seconds). Pull
the gun out of the staple.
• Repeat the operation, fitting in additional staples, until the repair has been completed.
8
230V ~ 50/60Hz
10 A
35 W
75 W
210 mm
250 mm
180 mm
1.2 m
3.4 m
IP20
Ø 0.8 mm
3.1 kg
EN
Publicité
