Beta 1368 Mode D'emploi page 7

INSTRUCTIONS FOR USE
Always use the following personal protective equipment:
• safety shoes;
• eye protection;
• heat protection gloves;
• protective mask against physical agents.
During use the staple gets overheated; never use the staple with bare hands at this stage.
Do not use the staple welder with humid or wet hands.
Carry out welding operations in well-aired, dry environments.
Do not inhale any harmful gases that may be released during welding operations.
Pay attention to melted plastic residues.
Before replacing the staple welder, make sure that the electrodes of the gun have cooled to room temperature.
STAPLE WELDER USE AND CARE
Do not subject the staple welder to voltage overloads; always check that it is free from defects.
When not in use, store the staple welder out of the reach of children. Do not allow persons unfamiliar with these instructions to
operate the staple welder.
Do not modify the staple welder. This can reduce the effectiveness of safety measures and increase operator risk.
Have the staple welder repaired only through a trained repair person and only using original replacement parts.
To clean the staple welder, use a dry cloth. Always disconnect the staple welder from the power supply mains before cleaning it.
Never use damp or wet cloths.
STAPLE WELDER SAFETY
Periodically check that the staple welder, the power supply cable and the staple welder cable are free from defects.
Do not use the staple welder if damaged, because electric shocks may occur.
Connect the power supply cable to the mains socket, checking that the mains voltage matches the voltage stated on the power
supply device (see TECHNICAL DATA table).
Do not cover the electrical device of the staple welder while using it. Allow for an adequate amount of space for ventilation.
Unplug the staple welder when not in use.
Do not use the staple welder in humid or wet environments; do not expose it to rain. Wet and contaminated environments
increase the risk of electric shocks.
Do not attempt to open or modify the staple welder when damaged or not running.
EN
7