Selve i-R Timer Plus Notice D'utilisation page 81

Transmitter programming procedure
1.
transmitter control light flashes three times).
Important: This transmitter is deleted after the group separation
is completed.
The receiver acknowledges activation of the group separation by
a short movementof the drives of 3 seconds.
If the receivers still run in a group, repeat the process for the
relevant drives.
Note: Group separation is ended either using a control com-
mand from a transmitter that has been learnt or as a result of
successful programming of the new transmitter.
To programme a transmitter which has not been programmed
using the STOP button follow the instructions in section 1.1.
2.
9 sec.
3 sec.
81
Fichier téléchargé sur http://www.servistores.com
First press the STOP button
and then the UP and DOWN
buttons as well. Keep all
three buttons depressed for
9 seconds, in order to start the
group separation (wait until the
Within the 3-second time slot,
stop the movement of the drive
using the STOP button on the
transmitter to be learnt. The
transmitter will be learnt and the
receiver will no longer be in
group separation mode.
GB