Pioneer PRA-BD11 Mode D'emploi page 14

Installation
PRA-BD12 output board connections
÷ Connect the 4-pin cable (L) already connected to connector E to connector e.
Secure the 4-pin cable (L) with a cable clamp before routing it.
Note:
The FFC cable (L) will be connected to the output board (connector f) in Step 11 3. Do
not make the connection in this step.
PRA-BD12
output board
4-pin cable (L)
10. Mount the rear bridge removed in Step 4 on the DVD recorder.
÷ Insert the rear bridge below the arms 4 in the PRA-BD11 input board and the PRA-
BD12 output board. Locate the rear bridge so that tabs 3 in the DVD recorder enter
the square holes 2 (one each on the right and left side) in the bridge. Use the four
screws 1 removed in Step 4 to secure the bridge. Install the four screws in the
following order: a, b, c, d.
Notes:
÷ Route the 4-pin cable connected to connector A and E underneath the rear bridge.
÷ Place the arms 4 of the PRA-BD11 input board and the PRA-BD12 output board on
top of the rear bridge.
PRA-BD12 output board
14
PRA-BD11 / PRA-BD12
En
e
F
PRA-BD11 input board
f
E
Rear bridge
FFC cable (L)
Do not make the
connection now.
Cable clamp
A
E
FFC cable (L)