Pioneer PRA-BD11 Mode D'emploi page 10

Installation
3. Remove inner cover F and inner cover R (PRV-LX10 only).
÷ Remove the thirteen screws (six type
1 screws, four type 2 screws and
three type 3 screws), then remove
inner cover F. Save the screws
carefully since they will be necessary
in Step 13 to reinstall the inner cover
F.
÷ Remove the six screws (four type 4
screws and two type 5 screws), then
disconnect the tab on the inner cover
R from the slot in the DVD recorder,
and remove inner cover R. Save the
screws carefully since they will be
necessary in Step 13 to reinstall the
inner cover R.
Note:
Make sure that the removed screws are not mixed up with the screws supplied with this
unit.
4. Remove the rear bridge.
÷ Remove the four installation screws and the rear bridge (these screws will be used
to reinstall the bridge in Step 10).
Note:
Make sure that the removed
screws are not mixed up with
the screws supplied with this
unit.
10
PRA-BD11 / PRA-BD12
En
Inner cover R
Inner cover F
Rear bridge
Tab