Inserting / Exchanging Gobos - HQ Power VDP575MHS16 Mode D'emploi

Inserting / Exchanging gobos

Install the gobos with the device switched off only. Unplug from mains before! If you wish to use other forms or
patterns as the standard gobos, or if gobos are to be exchanged, open the top cover of the head by loosening 2
screws on the top cover. Remove the fixation ring with an appropriate tool. Remove the gobo and insert the new
gobo. Press the fixation ring together an insert it in the front of the gobo.
d) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used. Have the material and the device itself checked regularly. Do not attempt to install the device
yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
e) Replacing the fuse
• If the lamp burns out, the fuse of the device might fuse, too.
• Only replace the fuse by a fuse of the same type and rating.
• Before replacing the fuse, unplug mains lead.
1) Unscrew the fuse holder on the rear panel of the base with a fitting screwdriver from the housing.
2) Remove the old fuse and install the new fuse in the fuse holder.
3) Replace the fuse holder in the housing and fix it.
5. Use
a. The moving head is controlled by 16 DMX channels:
CHANNEL 1 : pan movement (max. 530°)
CHANNEL 2 : tilt movement (max. 280°)
CHANNEL 3 : pan fine
CHANNEL 4 : tilt fine
CHANNEL 5 : scan speed adjust
CHANNEL 6 : focus
CHANNEL 7 : rainbow colour wheel
CHANNEL 8 : static colour wheel
CHANNEL 9 : prism, auto rotation
CHANNEL 10 : static gobo wheel
CHANNEL 11 : rotation gobo wheel
CHANNEL 12 : gobo rotation
VDP575MHS16 3 VELLEMAN