Installation Instruction; Overheating Protection - Ayce BHA001B Mode D'emploi

INSTALLATION INSTRUCTION

1. Take the appliance and all the accessory parts out of the packaging and check that the
appliance shows no signs of damage.
2. This appliance should be installed so that the lowest position was 1m above the floor.
(Figure 1)
3. Use Electrical Drill (size of head drill Ø6) drill 2 holes on the wall. The distance between
2 holes is 81mm.Then knock the plastic expansion bolts into the wall with a hammer
(Figure 2)
4. Use 2pcs of screws to fixate the plastic plate onto the wall. Place the plastic plate with
the arrow with "UP" indication pointing up. (Figure 2)
5. Have the holes on the wall mounting bracket inserted by the small tabs on the plastic
plate. (Figure 3)
6. Hang the shoe and boot dryer on to the wall. (Figure 4)
1M
Figure 1 Figure 2
OPERATION
1. Insert the main plug into a suitable wall socket and make sure that the timer / switch is on
"OFF" position.
2. Place the hoses into the boots or shoes which need to be dried.
3. Turn on the shoe dryer by timer/switch on "ON" position. (the red indicator LED would
light).
4. Or turn the timer/switch in clockwise rotation to set the shoe dryer working from 0
to120mins. (the red indicator LED would be lighted).
5. When the timer has run out or is manually turned to "OFF" position the shoe dryer will
stop working. (the red indicator LED is dimmed).
81mm
Figure 3 Figure 4
WARNING
To avoid drying out the material in shoes/boots with fragile materials, do not let the shoe
and boot dryer run for too long. It is better to dry the shoes in 2 shorter periods.

OVERHEATING PROTECTION

In case of heat accumulation a protective device against overheating will switch off heating
automatically. If the overheating protection has switched off, please proceed as follows.
1. Switch off the appliance ( pull out the plug ).
2. Remove the overheating cause (e.g. covered air-intake grid inhibition of air circulation,
dust fluff etc).
3. Let the appliance cool down for a few minutes.
4. Then the appliance can be switched on again.
CLEANING
1. Make sure the dryer is unplugged from the power and completely cooled down before
cleaning.
2. Check if dust or lint has collected on the inside. If necessary clean the appliance or the
outside with a damp cloth and use a vacuum cleaner on the top-and front grille.
STORING
1. Always disconnect the appliance, let it completely cool down and clean it before storing.
2. If you do not use the device for a long period, put back the unit and the instruction
manual to the original carton and store in a dry and ventilated place.
3. Do not place any heavy items on top of carton during storing as this may damage the
appliance.
42 | 43
GB