Pioneer PDK-FS04 Mode D'emploi page 12

Installation and assembly instructions
3
Attach plasma display to support legs.
Fit the stand's support columns to the bottom of the plasma
display as indicated by the arrows, then slowly insert them
vertically. Be extremely careful not to insert the support legs
of the stand into any part of the plasma display other than the
stand insertion slots. Note that doing so might damage the
plasma display panel or its ports or result in the warping of the
stand.
If the plasma display is fitted with handles, it is usually best to
hold the display by its handles when attaching it to the
support legs.
Be sure to work with at least one other person
when attaching the display.
Be careful not to allow your fingers get caught
Caution
between the display and support legs.
If the PDP bracket has been placed into the upper
bracket holes and speakers are to be installed
below the plasma display, care must be taken to
ensure that the display is firmly supported as its
position will be higher.
4
Use the long hexagonal bolts to fix the plasma
display to the support legs (4 locations).
If speakers are to be installed at the sides of the plasma
display, they should be attached at this phase.
See the installation instructions provided with your speak-
ers for instructions on how to install them.
12
En
Line up the support legs
with the bottom of the
plasma display as
indicated in the
accompanying diagram.
Long hexagonal bolts
(M8 x 35 mm)
5
Attach left and right glass stays to support column.
1 Insert the glass stays into the holes provided, pushing
them all the way into the holes so that they point slightly
downwards.
2 Press down on the tips of the glass stays to lower them
and fit the indentations into pins.
Glass stay
1 1
Glass stays may be inserted into the upper, middle, or lower
holes to adjust the height of the glass panel (The middle holes
are designed to be used for standard installation).
Glass stay (left)
Glass stay
(right)
6
Fit glass panel into glass stays.
Note
The glass panel should be installed with the warning label
facing upwards.
Glass panel
Indentation
Pin
Pin
2
1
2 2
Side with the
rubber guard is
the upper side.
Upper
holes
Middle
holes
Lower
holes
Caution
label