Toto TBV01406 Manuel D'installation Et D'utilisation page 6

3. Align and insert the trim
through the cartridge sleeve
cover and over the lining plate.
Make sure the water discharge
port is facing downward.
4. Keep the trim within
1/16"(1mm) of wall surface.
WARNING:
●DO NOT scratch
the cartridge
sleeve when
installing the
trim.
●DO NOT apply waterproof
caulk around the trim as
this may interfere with the
water discharge port
located underneath the
trim.
IV. Installation: Handles
a.Diverter Handle
1. Insert diverter handle into
connector facing upwards. Use
hex wrench (2.5mm) to fasten
screws. Secure the handle.
WARNING:
●Diverter handle should be
installed in the position
indicated on the trim.
●Cartridge is in a closed
condition from factory.
INSTALLATION PROCEDURE
Trim
Water discharge
port
Connector
Handle rod
Diverter
handle
Hex wrench
(2.5mm)
6
6
Cartridge sleeve
Set screw