Security Button; Creating A New Security Network (Network Ab) - Engel PL 2000 Manuel D'utilisation

Installation in homes with Existing HomePlug Networks:
1. Connect the HomePlug AV Pass-Thru Wall-Mount Ethernet Bridge to your device.
2. Plug the HomePlug AV Pass-Thru Wall-Mount Ethernet Bridge into a power socket.
3. Wait a few seconds for startup to be completed, and then check the LEDs
· The Power LED should be ON.
· The HomePlug LED will be ON
4. Hardware Installation is now completed, enjoy Powerline Internet connectivity.
Installation in homes with NO EXISTING HomePlug Network:
1. Make sure that another HomePlug 200M device is connected to your network at the router or directly
to a com-puter.
2. Connect the HomePlug AV Pass-Thru Wall-Mount Ethernet Bridge to your device.
3. Wait a few seconds for startup to be completed, and then check the LEDs
· The Power LED should be ON.
· The HomePlug LED will be ON
4. Hardware Installation is now completed, enjoy Powerline Internet connectivity.

2. SECURITY BUTTON

This section describes how to use Security button for confi guration in the following situations:

2.1 Creating a new security network (Network AB)

Two unassociated Adapters (Adapter A and Adapter B) are forming a new network—Network AB.
- 7 -