Additional Information - D-Link DSR-250 Guide D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Using a Console Connection

(RJ45-to-DB9 DCE)

The Services Router provides an serial port that

enables a connection to a computer or terminal

for monitoring and configuring the device. This

port is a RJ-45 connector, implemented as a

data communication terminal equipment (DCE)

connection.

To use the console port connection, you need the

following equipment:

1. A terminal or a computer with both a serial port

and the ability to emulate a terminal.

2. A RJ45-to-DB9 RS-232 with female connector.

(Already included in packing list)

3. If your Laptop or PC doesn't have RS-232

connector, a converter is required.

Note: DSR-250 does not come with RS-232

converter and these must be purchased separately.

To establish a console connection:

1. Plug the RJ-45 connector of the supplied

RJ45-to-DB9 cable directly to the console port

on the Services Router.

2. Connect the other end of the cable to a terminal

or to the serial connector of a computer

running terminal emulation software. Set the

terminal emulation software as following:

Baud rate: 115200

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

3. When you have correctly set up the terminal,

having previously followed the instructions

in section "Connecting Power and Turn the

Device On/Off" then switch on your device.

The boot sequence appears in the terminal.

4. Once the boot sequence completes, the

command prompt is displayed, the device is

ready to be configured.

Finalizing the Configuration

After initial setup, you should refer to the

companion publications found in PDF format on

the accompanying master CD for more infor-

mation on how to begin to configure the DSR-250

device.

D-Link Services Router User Manual

This document describes the general operation

and control of the Services Router firmware which

drives and controls the Services Router series

hardware. It includes examples of how to carry

out typical administrative tasks such as setting up

a VPN and how to use Services Router series in

various scenarios.

D-Link Service Router Log Reference Guide

This document describes all log messages that

might be generated by Services Router during

system operation.

D-Link Services Router CLI Reference Guide

This document describes all available text-based

commands that can be used on RJ45-to-DB9

Console or SSH interface to configure Services

Router during system operation.