Motion Detector - Chacon 34034 Mode D'emploi

3. Motion detector

When you open the detector, you will see a switch with the letters
«T» and «S» written. This allows you to choose between two
monitoring modes.
• "T" mode: This is the energy saving mode. As soon as the
detector detects a movement, the alarm sounds. Then starts
the sleep mode. If within 60 seconds a second movement is
detected, the detector will count down 60 seconds before a
second alarm can be issued.
• "S" mode: As soon as the detector detects movement, the alarm sounds. Then it
will take about 60 seconds for another alarm to sound. (Recommended mode).
4. Remote control button
• Padlock closed: Alarm on.
• Padlock open: Alarm deactivated. However, you still receive a
voice alert (see point 8)
• SOS Mode / Home Mode: When you press either button, the
alarm will be activated directly. You will have to press the button
on the remote control or on the central alarm to deactivate it.
5. Synchronisation of devices
1. Opening detector :
a. Press the button for the zone of your choice (1,2,3,4) until you hear a «beep».
b. Separate the two ends of the opening detector.
c. A beep will follow to let you know that the synchronization was successful.
2. Motion detector :
a. Place the face of the motion detector on a table and wait one minute before
synchronising.
b. Press the button of the zone of your choice (1,2,3,4) until you hear a «beep».
c. Turn the detector over and make a move in front of the detector.
d. A beep will follow to let you know that the synchronization was successful.
3. Remote control :
a. Press the button of the zone of your choice (1,2,3,4) until you hear a «beep».
b. Press a button on your remote control.
c. A beep will follow to let you know that the synchronisation was successful.
Note: if you hear a double beep, it means that the pairing didn't work.
EN