Battery Installation - Chacon 34034 Mode D'emploi

0.Introduction
Thank you for using this product.
• Please read all instructions carefully before using the product.
• Do not attempt to disassemble or repair the product yourself, as this will invalidate
the warranty.
• Remove the tab from each product before using them.

1. Battery installation:

• Avertisseur portable (alarme centrale)
1. Turn the unit over and slide the cover down to access the
battery compartment.
2. Insert the batteries, making sure that the polarity is correct
(+/-)
3. Close the compartment.
Note: If lights 1, 2, 3 and 4 remain on at the same time, it
means that the battery is low. Please change it as soon as
possible.
• Motion detector
1. Turn the unit over
2. Using a crosshead screwdriver, remove the screw on
the back of the motion detector.
3. Using a flathead screwdriver, separate the two parts to
access the battery compartment.
4. Insert the batteries, making sure that the polarity is
correct (+/-)
5. Close the compartment and seal it with the screw.
Note: When the battery is low, the LED will flash twice
every 15 seconds. For optimal use, we recommend that you test the device
every 3 months.
• Opening detector
1. Take the largest part of the detector and turn it over.
2. Using a flathead screwdriver, separate the two parts to
access the battery compartment.
3. Insert the batteries, making sure that the polarity is
correct (+/-)
4. Close the compartment.
EN