Important Safety Rules; Safety Symbols; Electrical Safety Guidelines - Olympia PS 22 CCD Mode D'emploi

Important safety rules

Please read the instructions thoroughly before using the device to make sure that you
are able to use all of its functions.
Keep children and pets away from the device. The device may only be used by adults.
The device can only be used by one person at a time. Do not conduct any other activi-
ties on the device (e.g. cleaning) when it is in use.
Have any necessary repairs performed by qualified specialist personnel.
Protect the device against direct sunshine, extreme heat and moisture.

Safety symbols

Do not reach into the infeed slot.
Keep ties, scarves and
loose clothing out of the area
around the infeed slot.
Pay attention to jewelry!
Caution: failure to observe these safety symbols can lead to serious injuries.
If an object (sleeve, tie, etc.) is inadvertently fed into the infeed slot, pull out the
mains plug immediately.

Electrical safety guidelines

Pull out the mains plug before emptying the collecting baskets, cleaning the device or
-
if the device is not going to be used for a long time.
If the mains cable, mains plug or the device itself is damaged do not operate the
-
device any longer (danger of injuries).
Do not overload the recommended capacity of the mains socket.
-
Do not make any alterations to the mains cable as it has been designed for the spe-
-
cified mains voltage.
Do not insert paper clips or
staples into the infeed slot.
Keep long hair out of the area
around the infeed slot.
Attention! No cassettes or
diskettes!
Intended use
The PS 22 CCD shredder may only be used to shred paper, CDs or credit cards in the
infeed slots provided. The material to be shredded must be dry and must correspond
to the specifications listed in the technical data. Shredding other materials can lead to
injuries (for example, if solid material splinters) or damage to the device (destruction of
the cutting unit, etc.).
Do not shred endless paper documents with this device. Remove all paper clips and
staples before feeding paper into the device.
The device may only be used indoors in dry rooms.
Take the device carefully out of the packaging and install it on the paper collection
-
basket. Insert the inner collecting basket (for CDs and credit cards) at the top in the
paper collecting basket and slide it to the front as far as possible.
Plug the mains cable into the socket. Please observe the energy supply specificati-
-
ons on the back of the device in your safety measures.
The socket and the mains connection of the device must be freely accessible for
-
safety reasons so that the power supply can be disconnected in emergencies.
The sliding switch (REV / OFF / AUTO) on the device has the following
Functions: AUTO position: the device is ready for operation.
The device is equipped with microswitches. Shredding operating of the respective cutting
unit starts automatically as soon as material is fed through the infeed slot.
- Insert the paper, individual CD or individual credit card in the respective infeed slot in the
cutting unit.
The device runs forwards and draws the paper in.
-
The device switches off automatically after the shredding cycle. The motor carries on
-
running for another 2-3 seconds to remove the remaining paper from the cutting unit.
OFF position: The device is switched off.
REV position: the cutting unit runs in reverse. To hold the rest of the material back, you
can push the sliding switch in the REV position. The cutting unit runs backwards and
pushes the material back.
Caution: the sheet capacity given in the technical data may not be exceeded as oth-
erwise a paper jam will occur. Remember that the thickness of the paper increases
when it is folded and the recommended sheet capacity may be exceeded in this way.
Reduce the quantity of paper fed if it is coarse fibre paper.
it is recommended not to fill the paper collection basket up to the cutting unit. This
prevents cut material becoming jammed in the cutting unit.
Empty the paper collection basket at regular intervals.
Starting up
Operation