Poulan Pro PP2822 Manuel D'instructions page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TOP SIDE
OF BLADE
CAUTION:
If the clearance between the
cutting blades is set too wide, the blades will
not cut correctly. If the blades are adjusted too
tight, overheating may occur.
REPLACE SPARK PLUG
Replace spark plug each year to ensure the
engine starts easier and runs better. Set
spark plug gap at 0.025 inch (0.6 mm). Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
(19 mm) socket wrench.
4. Reinstall the spark plug boot.
WARNING:
Perform the following
steps after each use:
Allow engine to cool, and secure the unit
before storing or transporting.
Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
Store unit with the blade cover installed.
Position unit so that any sharp object can-
not accidentally cause injury.
Store unit and fuel well out of the reach of
children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
Clean the entire unit.
Store in a clean dry area.
Clean all parts and check for damage.
Have damaged parts repaired or replaced
by an authorized service dealer.
Keep all nuts, bolts, and screws tight.
Lightly oil external metal surfaces, includ-
ing the blade.
Install the blade cover.
Empty fuel tank before storage.
To oil the blade, do the following:
Stop the engine and allow blade to come to
a complete stop.
Ensure ON/OFF switch is in the OFF posi-
tion.
Disconnect the spark plug wire.
Apply a light machine oil along the edge of
the top strap as shown.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by running it dry
of fuel, then remove fuel cap/retainer assem-
bly from tank. Pull filter from tank and remove
it from the fuel line. Install new fuel filter on fuel
line; reinstall parts.
STORAGE
Top Strap
FUEL SYSTEM
Under FUELING ENGINE in the OPERA-
TION section of this manual, see message la-
beled IMPORTANT regarding the use of ga-
sohol in your engine. Fuel stabilizer is an ac-
ceptable alternative in minimizing the formation
of fuel gum deposits during storage. Add stabi-
lizer to gasoline in fuel tank or fuel storage con-
tainer. Follow the mix instructions found on sta-
bilizer container. Run engine at least 5 minutes
after adding stabilizer.
During storage of your gas/
oil mixture, the oil will sepa-
rate from the gas.
We recommend that you
shake the gas can weekly
to insure proper blending of
the gas and oil.
ENGINE
• Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.
-- 8 --
Fuel
Filter
Fuel Line
OIL
HELPFUL TIP

Publicité

Table des Matières
loading

Table des Matières