KRESS HLG E 1600 Mode D'emploi Original page 9

tion 3–6).
Shrinking of PVC and teflon tubes (potenti-
ometer position 3–5).
PVC, polystyrol, acrylic glass and plexiglass
can be brought into the desired shape with
the 1600 HLG E.
PVC, polystyrol at 300 °C (approx. potentiom-
eter position 3).
Acrylic glass and plexiglass at approx. 500 °C
(approx. potentiometer position 5).
Weld-seal cracks in polyethylene containers,
or polyethylene or PVC pipes, e.g. eaves gut-
ters, water pipes with welding bands (potenti-
ometer position approx. 3).
If a shaping operation has been completed,
the further processing can be speeded up by
blowing with the 1600 HLG E in potentiome-
ter position 1.
Dry construction joints safely before further
processing with the 1600 HLG E (potentiom-
eter position 1–6).
Warming up of parts to be joined by means of
pressing.
The 1600 HLG E is also ideal as a flameless
Bunsen burner in the large temperature
range from approx. 80– 600 °C.
Hot air may be used to help loosen screws
that have been overtightened.
Speeding up of adhesive operations.
Thawing.
Thawing off of refrigerators and freezers (At-
tention! Plastics may be distorted under
heat!).
Warranty
1. This power tool has been carefully tested and has
been subjected to a strict quality control process.
2. We guarantee the free-of-charge repair of faults in
the power tool that arise within 24 months from the
date of purchase at the end user's premises and
which can be attributed to a material or manufactur-
ing defect. In certain countries there are special reg-
ulations concerning the warranty terms. We reserve
the right to repair faulty components or to replace
them. Replaced items become our property.
3. Inappropriate use or handling and opening up the de-
vice by unauthorised repair centres leads to the war-
ranty becoming void. The warranty does not cover:
mechanical damage due to falls etc., damage caused
by penetration of water or other fluids, cut and dam-
aged cables, motor damage and mechanical damage
caused by inappropriate overloading, wear parts e.g.
carbon brushes, drill chucks, chuck keys, worn drill-
ing spindles, motors, mains cables, batteries, saw
blades, grinding discs, dust bags, accessories in gen-
eral (drill bits, chisels etc.). Details of the various toll
wear parts can
spareparts.kress-elektrik.de or from one of our serv-
ice centres.
4. The warranty may only be enforced when defects are
reported without undue delay (including shipping
damage). Warranty implementation does not extend
the warranty period.
5. If you need to apply the warranty, send the original
purchase receipt together with the device to us or to
the relevant service centre.
6. The warranty obligations assumed by us shall ex-
clude any further claims on the part of the buyer, in
particular the right to cancellation of a sale, reduction
and the assertion of damage claims.
7. However, the buyer shall have the right to either a re-
duction (in the purchase price) or the cancellation of
the sales agreement should we fail to eliminate any
defects within a reasonable period of time.
8. This does not exclude compensation claims in ac-
cordance with §§ 463, 480 Para. 2, 635 BGB caused
by the failure of assured properties.
The provisions defined in Items 7 and 8 only apply
to the Federal Republic of Germany.
English 9
be obtained from
1600_HLG_E-EN / 1005
EN
http://