Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Original instructions "Cordless caulking gun"
English
1
On-Off switch
2
Locking button for continuous operation
3
Blow-out tube (hot-air outlet)
4
Housing with integrated shield tube
5
Lid with air-suction intakes
6
Rotary potentiometer for setting temperature
7
Pull-out support for horizontal operation
Technical data
Power max.
Temperature range
Air flow
Weight approx.
Use
The hot-air blower is universally suitable for work
with a wide variety of materials. See the Sample
application in these operating instructions.
The hot-air blower 1600 HLG E makes possible an
electronic continuously adjustable temperature
setting 80– 600 °C with a large volume of air of up
to 400 litres/min.
Double insulation
Our equipment is designed in accordance with
European regulations (EN standards) for the ut-
most safety of the user. Machines with double in-
sulation always carry the international
The machines do not require earthing. A two-core
cable is sufficient. The machines are interference-
suppressed in accordance with EN 55014.
Safety instructions and prevention of
accidents
Before operating the machine, please read
through the operating instructions completely, fol-
low the Safety Instructions in this manual as well
as the general Safety Instructions for Power Tools
in the accompanying booklet.
1600 Watt, adjustable from
160–1600 Watt according
to temperature range
80–600 °C, adjustable with
rotary potentiometer
up to 400 litres/min.,
according to temperature
range
0.55 kg
symbol.
Attention! Safety and accident preven-
tion! Important information which you
must take note of:
The 1600 HLG E produces hot air to a max. tem-
perature of 600 °C. This high temperature is at-
tained by having the air flow past a glowing
resistance wire. At max. temperature setting the
filament becomes red hot, without producing a na-
ked flame however. The danger of inflammability
is thus slight. The user should, however, take the
necessary care when working with inflammable
materials at these high temperatures.
Always have a fire extinguisher ready!
There is a danger of fire when working on
buildings.
Do not use the hot-air blower in rooms in
which easily inflammable materials, liquids or
gases are present.
Caution! Danger of fire and explosion when
working with plastics, paint, lacquer and sim-
ilar materials. Toxic gases may develop,
therefore work only in well ventilated rooms!
Do not use the appliance in damp rooms or if
it is damp itself. Do not use outdoors if it is
raining.
Caution! Danger of burning at metal blow-out
tube! Do not touch!
Do not hold blow-out tube close to objects
during or immediately after use! Put the hot-
air blower away in such a way that the still
warm blow-out tube does no harm.
If the motor fails, switch the hot-air blower off
immediately, as otherwise heat accumulates
inside it.
Do not impair the air suction or the hot-air out-
let. Also do not use any additional nozzles
which would alter the air-outlet profile, unless
they were approved for use by the manufac-
turer, as the resulting accumulation of heat
will damage the appliance.
The hot-air blower is constructed in such a
way that it produces a concentrated stream of
air without additional nozzles.
Never point the hot-air stream at persons and
never look directly into the jet orifice on the
blow-out tube.
Do not leave the switched-on hot-air blower
unattended!
English 7
EN
1600_HLG_E-EN / 1005
Publicité
Table des Matières
