Declaration Of Conformity; Battery Charging; Changing The Tool - Berner BACMC-10,8V LI Notice Originale

OBJ_BUCH-890-004.book Page 17 Wednesday, August 19, 2015 9:45 AM

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with all relevant provisions of the direc-
tives 2011/65/EU, until 19 April 2016:
2004/108/EC, from 20 April 2016 on:
2014/30/EU, 2006/42/EC including their amend-
ments and complies with the following standards:
EN 60745-1, EN 60745-2-4.
Technical file (2006/42/EC) at:
Berner Trading Holding GmbH,
Bernerstraße 6,
74653 Künzelsau
GERMANY
Armin Hess
Chairman of the Management Board
25.06.2015, Berner Trading Holding GmbH
Bernerstraße 6
74653 Künzelsau
GERMANY
Assembly

Battery Charging

 Use only the battery chargers listed on the ac-
cessories page. Only these battery chargers are
matched to the lithium-ion battery of your power
tool.
Note: The battery supplied is partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger before us-
ing your power tool for the first time.
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
Removing the battery
To remove the battery 2, press the unlocking but-
tons 1 and pull the battery out of the machine to the
rear. Do not exert any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-control
indicator 4 indicate the charge condition of the bat-
tery 2. For safety reasons, it is only possible to
check the status of the charge condition when the
machine is at a standstill.
1 609 92A 1DR • 19.8.15
To indicate the charge condition, press and hold
button 3 of the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green

Changing the Tool

 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as dur-
ing transport and storage, remove the battery
from the power tool. There is danger of injury
when unintentionally actuating the On/Off
switch.
 Wear protective gloves when changing appli-
cation tools/accessories. Contact with the
application tool/accessory can lead to injuries.
Selecting the Application Tool/Accessory
Accessory
HCS wood
segment saw
blade*
BIM segment
saw blade*
HCS plunge
cut saw
blades, wood*
BIM plunge
cut saw
blades,
metal*
BIM plunge
cut saw blade,
wood and
metal*
HM-Riff
segment saw
blade*
HM-Riff delta
plate*
Scraper,
rigid*
* optional accessory
Capacity
≥2/3
≥1/3
<1/3
Reserve
Material
Wooden
materials, plastic
Wooden materi-
als, plastic, non-
ferrous metals
Wooden materi-
als, plastic, gyp-
sum and other
soft materials
Metal (e. g. un-
hardened nails,
screws, smaller
profiles), non-
ferrous metals
Wood, metal,
non-ferrous
metals
Grouting joints,
soft wall tiles,
glass-fibre rein-
forces plastic
and other
abrasive
materials
Carpets,
coverings
English | 17