STERWINS EHT2-60.4 Notice De Montage, Utilisation Et Entretien page 185

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
To turn ON, press the safety switch on the front handle and the on/off switch on the rear handle
at the same time. To turn OFF, release either the on/off switch or the safety switch. Always
unplug the hedge trimmer from the power source when finish using.
Trimming : Illustration 4.4 to 4.6
NOTE: Try to keep the cutting device angled at approximately 15° to the cutting surface.
1. Cut and remove branches exceeding the cutting capacity of this product using a proper
pruner before operation.
2. Move the cutting device lightly through the cutting surface in a sweeping motion following
the shape of the hedge or shrub.
3. A slight tilt downwards of the cutting device in the direction of motion is recommended for
optimum cutting performance.
4. Do not to rush and do not attempt to cut too much with one stroke of the cutting device.
5. First cut both sides from the bottom cutting upwards to the top. This will prevent any of the
trimmings falling into the path of the area still to be cut .
6. After cutting the sides proceed to the top. Try to keep the cutting device angled at
approximately 15° to the cutting surface.
7. Cut in a number of stages if the area being cut is particularly long to achieve a better result;
smaller trimmings will allow for easy composting.
NOTE : WHEN SHAPING IT IS ADVISABLE TO ACHIEVE A
TRAPEZOIDAL SHAPE. A TRAPEZOIDAL CUT CORRESPONDS TO THE
NATURAL GROWTH OF PLANTS AND RESULTS IN OPTIMAL HEDGE
GROWTH, AS IT WILL EXPOSE MORE LIGHT TO THE LOWER END OF
THE HEDGE.
8. Lubricate the internal surfaces of the blade if the cutting device overheats during operation.
NOTE : WHILE TRIMMING, THE CUTTING DEVICE MAY BE BLOCKED.
SO THE PRODUCT WILL TURN OFF AUTOMATICALLY DUE TO OVER
CURRENT. THEREFORE RELEASE THE ON/OFF SWITCH AND THEN
START AGAIN TO GO ON WITH TRIMMING.
4. TRANSPORTATION
Transporting the machine may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country, in
order to respect them all.
Pull the power plug from the socket. Let the machine cool for 2 hours outside before transport
it. Ensure temperature during transportation will never be out of temperature range given on
chapter storage. Protect the product from any heavy impact or strong vibrations which may
occur during transportation in vehicles. Secure the product to prevent it from slipping or falling
over.
185
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN

Publicité

Table des Matières
loading

Table des Matières