Danby Designer DCF145A1WDD Guide D'utilisation Et D'entretien page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Care and Maintenance
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary - use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Does not work
Freezer runs continuously
Internal temperature not cold
enough
SOME IMPORTANT RULES FOR THE CORRECT USE OF
THE FREEZER
Never place hot foods in the freezer.
Never place spoiled foods in the unit.
Don't overload the unit.
Don't open the lid unless necessary.
Should the freezer be stored without use for long periods, it
is suggested, after careful cleaning, to leave the lid open to
allow the air to circulate inside the unit in order to avoid the
possibility of condensation, mold or odors.
Tel: 1-800-26-
POSSIBLE CAUSE
No power to unit
Power cord is unplugged
Wrong voltage is being used
Temperature set too low
(cold)
Lid is not closed
Hot food was inserted
Lid opened too long or too
often
Close proximity to heat
source or direct sunlight
No power to unit
Power cord is unplugged
Temperature set too high
(warm)
Lid is not closed
Hot food was inserted
Lid opened too long or too
often
Air fl ow obstruction
Wrong voltage is being used.
Close proximity to heat
source or direct sunlight
(1-800-263-2629)
Check connection of power
cord to power source
Plug in unit
Use proper voltage
Set temperature control to
warmer setting
Close lid securely
Be sure food is at room tem-
perature before inserting
Minimize lid openings / dura-
tion
Do not place unit close to
heat sources or direct sun-
light
Check connection of power
cord to power source
Plug in unit
Check setting and adjust as
needed
Close lid securely
Be sure that food is at room
temperature
Minimize lid openings / dura-
tion
Allow room for air to circulate
around unit
Use proper voltage
Do not place unit close to
heat sources or direct sun-
light
7
SOLUTION

Publicité

Table des Matières
loading

Table des Matières