Bosch PushDrive Notice Originale page 25

Operation
Start-up
Setting the rotational direction (see figure A)
Do not use the rotational direction switch (3) when the power tool is in opera-
u
tion, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch (3) for-
wards.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction
switch (3) backwards.
Locking the spindle (see figure B)
To lock the spindle in place, slide the rotational direction switch (3) into the middle posi-
tion.
This allows screws to be driven in even when the battery is discharged and enables the
power tool to be used as a screwdriver.
Preselecting the torque
The torque presetting ring (5) can be used to preselect the required torque in six stages.
Once the set torque has been reached, the application tool will be stopped.
Stage 1:
Lower torque for driving in screws with a small diameter or for use with soft materials.
Stage 6:
Higher torque for driving in screws with a large diameter or for use with hard materials.
Switching the tool on/off (see figure A)
To start the power tool, exert pressure on the spindle and maintain this pressure to con-
tinue using the power tool.
To switch it off, stop exerting pressure on the spindle.
Battery charge indicator
30 % 60 % 100 %
Bosch Power Tools
The battery charge indicator on the power
tool consists of three green LEDs. It indic-
ates the state of charge of the battery for a
few seconds after the power tool is
switched on and off.
1 609 92A 48W | (07.05.2018)
English | 25