XciteRC XRC 6S Mode D'emploi page 45

Function menu
THRO.Curve
F U N . M E N U
T H R O . C U R V
M O N I T O R
P I T . C U R V
Throttle curve operation
• Press "up" to select "FUN MENU"
and press "ENTER" to come to the
interface.
• Press "up" or "down" to select
"THRO CURV" ,and now the
shadow area is the item that can
be set currently. Press "ENTER" to go to the next step.
• Press "up" or "down" to select the throttle curve point. There are 5 points, they are L,1,2,3,H. Press "INC"
or "DEC" to set the corresponding value separately and the throttle curve will change accordingly.
• There are three throttle curves to be selected, normal, "IDLE 0" and "IDLE 1" by the switch at the left top
of the transmitter.
• After your setting, press "EXIT" to save the setting and leave the operation.
Remark: the transmitter can save 3 groups of different throttle curves.When you make 3D fly, please ask for
instruction from experienced pilots.
Monitor
F U N . M E N U
T H R O . C U R V
M O N I T O R
P I T . C U R V
Monitor system
• Press "up" to select "FUN MENU" and press "ENTER" to come to the interface.
• Press "up" or "down" to select "MONITOR" ,and now the shadow area is the item that can be set cur-
rently. Press "ENTER" to go to the next step.
• When you move the sticks or channel switches, you can find the corresponding channel bars will change
accordingly. This function is designed to monitor the working conditions of the transmitter.
• After your setting, press "EXIT" to save the setting and leave the operation.
Remark: this function helps you adjust the setting, neutral trim as well as channel inspection.
50500000 Sender X-6S
T H R O . C U R V
N O R
ENTER
I 5 0
345
O 5 0
L 1 0 0
T H R O . C U R V
I D L E 1
I 2 0
O 2 0
H 3
1
ENTER 2
3
345
4
5
6
T H R O . C U R V
I D L E 0
IDLE SW
I 2 0
NOR/POS0/
O 2 0
POS1
H 7 5
IDLE SW
EN
45