Menu; Navigation - XciteRC XRC 6S Mode D'emploi

Menu

Function menu (FUN.MENU):
EN
Heli
D/R
SUB.TRIM
TRAVEL
CH.REV
SWASH.MIX
GYRO.SEN
THRO.CURV
MONITOR
PIT.CURV
THRO.HOLD
System menu (SYS.MENU):
Heli
MODEL.SET
PLANETYPE
STICKMODE
STICK.ADJ
TRAINER
• MODEL SET -- Here you can set the parameter of the model, rename, save and format to recover to the
factory setting.
• PLANE TYPE -- Four types of plane are selectable. Helicopter, fixed wing(plane), V-Tail and Delta.
• STICK MODE -- Operating stick selection: Mode 1 (right throttle), Mode 2 (left throttle), Mode 3 and Mode 4.
• STICK ADJ -- Neutral position setting of 4 proportional channels controlled by the operating stick.
• TRAINER -- This menu can be used for simulation software setting.
Preset model memories
Flybarless 200 Trainer: FB70
Flybarless 200 3D: FB80
Flybarless 245 Trainer: FB90
Flybarless 245 3D: F100
Quadrocopter HotBee 3D: F120
Paracopter: MOD6

Navigation

With the Down and Up buttons you select the function od the system menu after power on (selection is shad-
owed). In the menus you select the function with the Up- and Down-buttons (shadowed). YOu maybe do
not see all the functions. These will be visible, when you extend the border with the Up- and Down-buttons.
You choose the shadowed function by pressing the ENTER-button. The EXIT-button leave the function and
goes to the previous level.
34
Plane V-Tail
D/R D/R
SUB.TRIM SUB.TRIM
TRAVEL TRAVEL
CH.REV CH.REV
MONITOR MONITOR
V-TAIL
Plane
MODEL.SET
PLANETYPE
STICKMODE
STICK.ADJ
TRAINER
Delta
D/R
SUB.TRIM
TRAVEL
CH.REV
MONITOR
DELTA-MIX
V-Tail
MODEL.SET
PLANETYPE
STICKMODE
STICK.ADJ
TRAINER
Menu
Delta
MODEL.SET
PLANETYPE
STICKMODE
STICK.ADJ
TRAINER
50500000 Sender X-6S