XciteRC XRC 6S Mode D'emploi page 32

The transmitter
EN
Antenna
IDLE-switch
(Heli.) A/E/R DR
(Aile, Elev, Rudd)
Digital trim
Left stick
Tragriemen-Öse
Digital trim
EiPower switch
LCD-Display
Receiver binding
The Binding processing
• Turn on the transmitter, then connect the power of receiver by pressing the receiver „BIND" button till the
light turn on GREEN which means the binding is successful.
• Caution: make sure the RX and TX is within one meter, and around 10 meters no similar device.
• If the light flashes, it means the binding failed, please repeat above steps.
32
HV.PT
LED
Up
Down
Exit
The transmitter
Handle
HV.TH
TH.Hold (Heli)
CH6 (Flugmodell)
GYRO.SENS. (Heli)
CH5 (Plane)
Digital trim
Right
Stick
Digital trim
INC (Timer-Start)
Charging jack
DEC (Timer Reset)
ENTER
50500000 Sender X-6S