Geemarc LoopHEAR 20AD Mode D'emploi page 4

(Microphone/ T-coil)
1. The headset is powered by a 3.7V lithium polymer
rechargeable battery which is sealed inside the
headset. This type of battery should last for many
years and has over 300 recharging cycles.
2. We recommend that the battery be charged for about
2 hours before the system is used for the first time.
3. Place the headset in a charging cradle in the Charger
base. Verify that the red LED charging indicator is ON.
When the battery is fully charged a green LED turns
on.
Left cradle
charging
Indicator
(Red/Green)
NOTE: It is not possible to overcharge the battery. We
recommend that the headset be placed in the charging
cradle when not in use.
Internal Microphone
Mode Switch
INTRODUCTION
Balance Adjustment
(Use tool
3
)
Right cradle
charging
Indicator
(Red/Green)