Range Of Use; Scope Of Delivery And Optional Accessories; Installation; General Installation Instructions - T.I.P. SPF Serie Mode D'emploi

bed, and filtered out. The filtered water is returned from the bottom of the filter tank, through the 4 po-
sition valve and back through the piping system.

4. Range of use

This swimming pool filter set is for cleaning of swimming pool water. This device is for the private use
and not for industrial or commercial usage.
Do not store swimming pool disinfectant near the filter sets.
Prevent chemicals and vapors come with the filter set to touch and spoil the material.

5. Scope of delivery and optional accessories

This product includes:
A sand filter tank including base plate, 4-way valve, one pump, two bags with connection and installa-
tion accessories (see chapter 6 "Installation"), an instruction manual.
Check the contents for completeness. If possible, keep the packaging until the end of the warranty pe-
riod. Dispose of packaging materials in an environmentally sound manner.
In order to chlorinate your pool suitably and continuously, we recommend the use of the chlorine feed-
er "ChlorMax" (item No. 30311).
To simplify the installation, you can use the connectors developed by T.I.P. (item No. 30966 for
Ø 32 mm hoses, item no 30967 for Ø 38 mm hoses).
Depending on the application, additional accessories may be required (see chapter "How to order
spare parts").

6. Installation

6.1.

General Installation Instructions

During the entire process of installation, the device must not be connected to the
electrical mains.
The pump and the entire port system must be protected against frost.
All connection lines have to be perfectly tight since leaking lines may affect the performance of the
pump and cause considerable damage. If required, please use a suitable sealant to make the installa-
tion airtight.
Avoid when tightening screw excessive force that may cause damage.
When laying the connection pipes, you should make sure that the pump is not exposed to any form of
weight, vibration or tension. Moreover, the connection lines must not contain any kinks or an adverse
slope.
Please observe the illustrations, too, which are contained as an attachment at the end of the present
operating instructions. The numeric and other details included in brackets below refer to these illustra-
tions.
Please observe the graphic figures in this manual. The numbers and other indications in brackets refer
to the following graphic figures in this text.
3
18