Set-Up; Std Program; Uni Program - hoxter ABRA 6.1 Manuel D'installation Et D'utilisation

SET-UP

SETTING UP THE PRODUCT AND THE COMMUNICATION CHANNEL
To access the display batteries, press the bottom of
white back cover in the middle and tilt it to the back
(see figure) Remove the strip between the battery and
the contact and close the cover.
ABRA 6.1 is ready for use right after unpacking and
1
plugging it in. The communication channel
and program
is suitable for all Hoxter fireplace inserts when the
temperature sensor is installed in the designed
position on the insert.
To enter the set-up mode, press the OK button on the display for 10 seconds
2
until two blinking horizontal lines appear on the display. Then long-press the
FuV button on the control unit until the orange indicator light is blinking fast.
After entering the set-up mode, select the Std,
3
the arrows and confirm with the OK button.

STD PROGRAM

It is not possible to extend or shorten the phase of active burning in the
4.1
program. The starting temperature

UNI PROGRAM

Uni
The program is designed for individual builds of fire chambers or to
4.1
shorten / extend the active burning phase.
Select the starting temperature
OK to confirm. Choosing the starting temperature depends on the location
of the temperature sensor. It is necessary that the
always reached during the operation.
20
Std are set by default. The
T
Ch-1
Std mode
Uni
or
T
it set to 250°C. Continue to step 5.
start
80°C (t 80) or 250°C (t250) and press
start
T
start
tESt
program using
Std
(80°C or 250°C) is